VIB HD 56 MEDIUM DEFLECTION MOUNTS HIGH LOADS
DESCRIPTION
A complete range of high deflection omnidirectional mounts. They are made of two cast iron inserts,
a threaded steel plate holding the fixing interfaces is added to one end.
The elastomer is a specially developed natural rubber to meet the navy requirements (Other
materials can be delivered on request).
ADVANTAGES
These mounts will provide both a very high level of vibration attenuation and a high shock capacity to
reduce the transmitted acceleration. It’s structural resistance correspond to a continuous acceleration
of 10 g at the maximum load.
The range is made of several references with a load range ranging from 1125 daN up to 7000 daN per mount.
These mounts meet both the European and North American shock standards.
The metalwork are treated against corrosion.
DIMENSIONS IN mm (for Shapes 1 & 2)
OPERATING CHARACTERISTICS (for Shapes 1 & 2)
OPERATING CHARACTERISTICS (for Shapes 1 & 2)
➤ Axial and radial natural frequency : 4 to 7 Hz depending on load.
➤Displacement under shock : 56 to 60 mm depending on the axis.
For the E1N-4001mount, it can be increased to 63 mm using spacers.
➤ Structural strength : 10 g at maximum load.
➤ Temperature range : - 30°C up to + 80°C.
ASSEMBLY
These mounts are designed to carry load in compression and should be installed on a smooth surface.
The equipment in Men second using 4 M20 bolts (shapes 1 and 2).
For a better result, the load per mount should be evenly distributed. In the case of a tall suspended
equipment, these mounts can be used as stabilizing devices. They will be secured to the equipment
only after stabilization of the base mount.
These mounts are not designed to carry a permanent load in shear or in tension.
All connections with the suspended equipment must be flexible and capable to accept high
displacement allowing the suspensions to work properly.
We strongly recommend to have your installation approved by our technical department before
ordering the mounts.
